1K Etch Primer

For the best possible preparation of metal substrates, use Silicone Remover 174469 for thorough cleaning. This etch primer is ideal for spot and partial painting.

Here's how you do it
When used as a primer: 1-2 layers,

After airing for 10-50 minutes (20 °C) one of the following products can be continued as needed: ColorMatic 1K Fillers, 1K Primer Fillers HG2-HG6, HG8 (not HG1 and HG7!), 2K Hi-speed Primer.

When used as a welding primer. A light layer

Remove all rust damaged areas, clean the surface thoroughly and sand. The area must be dry and free of grease and dust. Clean the undercoat with ColorMatic Silicone Remover no. 174 469 Shake the can well for 2 minutes

Always perform test spray. Wear a suitable respirator (recommended type A2/P3).