PB300 Synthetic Primer Binder DTM (Tintable)

Preparation: For more detailed information go-to TI-Substrate and Pre-treatment on Colour Retrieval System (CRS) or website www.valsparindustrialmix.com.

Substrates:

Iron, steel, cast iron, galvanized steel, aluminum, glass fiber reinforced plastics.

Other: Solvent resistant surfaces, cleaned/sanded/hardened original and cured coatings.

Iron/steel: Abrasive shot blasting is recommended or dry sanding P80 – P180

Aluminum: P180 – P240

Galvanized: Sweep blasting recommended

Paint finishes: P240 – P320 (Please, check and change abrasive paper regularly as required)

Cleaning: Surface must be dry and free from any contamination, e.g. oil, grease, release agents. Use RS605/607/609 Universal Reducer for metal substrate and AD690 Solvent Degreaser for paint finishes.

Recoating: Can be recoated with TB300 Synthetic Topcoat also in combination with AD300 matting agent and AD309 Synthetic High Build Additive. For more detailed information go-to Technical Data Sheet (TB300/AD300/AD309).

Mixing ratio with Color Toner: (By volume)

PB300 Synthetic Primer Binder DTM tintable: 80 parts

CT Range of VIM Color Toners: 20 parts

Mixing ratio with Reducer: (By volume)

PB300 Synthetic Primer DTM (colored): 100 parts

RS300 Synthetic Reducer: 15 - 30 parts

Mix stick: Use the Mixing stick M2 4:1 (74-202 = 3:1/4:1) or M6 Universal cm-stick (74-206 standard) / M7 (74-207 large)

Viscosity: 20 – 28 sec. (DIN4/20°C)

For spraygun setup, see technical datasheet.

Air–dry at 20°C its Dust Free: 20 – 30 minutes and Dry: 6 – 8 hours

Force–dry: 30 minutes / 60°C object temperature

IR–dry: 10 – 12 minutes (The panel must not exceed 90°C)

Use suitable respiratory protection (air fed respirator strongly recommended).