Product added to basket
Loading
Loading

Teknos

Teknodur 3510-23 Base 1

About the product

Teknodur 3510-23 is a two-component reaction-drying topcoat for plastic and MDF. Resistant to weak acids and bases, as well as solvents. Gloss (60°) Approx. 30.

Overcoating must be carried out within a maximum of 36 hours, as otherwise there may be a risk of poor adhesion between the layers. Possibly. application of screen printing must be done within 24 hours to achieve adequate adhesion. Used for indoor items where a hard-wearing and robust surface is required.

Priming, priming

Optimum adhesion is achieved by priming with one of the following types:

PLASTIC: TEKNOSEAL 1120, TEKNODUR FILLER 3310.

MDF: TEKNODUR FILLER 3310.

Application method Conventional spraying

MIXING OF COMPONENTS:

In order to achieve a satisfactory result, it is important that the hardener is incorporated correctly. Inadequate stirring or incorrect mixing ratio results in insufficient curing and poorer film properties. It happens in the first 15 min. after the addition of hardener, an increase in viscosity. Final adjustment of the spray viscosity must then be made.

Application conditions

The surface to be treated must be dry. During application and drying, the air temperature must be above +10 °C and the relative humidity below 80%. Adhesion and attack to the plastic type must be tested before actual production, as there can be large variations depending on the plastic quality.

Read more Read less

Teknodur 3510-23 - Ts 0001 White Base 1

  • Stock: 6 in stock • While stock lasts
  • Item no.: 3510-23-1-9
  • Unit: 9 L
Limited quantity - item is being omitted
;
Recommended accessories