Teknosafe Flame Protect 2408-00

Used as an industrial fire retardant topcoat as part of a system called Teknos FR Façade with TEKNOSAFE 2407- 00 to improve reaction to fire (EN 13501-1) on external wooden surfaces - see https://www.teknos.com/products/teknosafe -flame-protect-2408-00/.

Before use, contact Teknos to check the suitability of the product in question.

The fire-retardant properties are classified according to B-s1, d0 / B-s2, d0 EN 13501-1 (SBI test) in certain systems. Durability classes for reaction to fire on fire-retardant wooden facades treated with Teknos FR Façade in end-use use are according to EN16755 DRF class EXT. Teknos FR Façade covering has achieved classification according to SP-Fire 105 and fire resistance K₁10 and K₂10.

Technical data

Area of ​​application Dressing boards

Recommended substrate Softwood, Stick-glued wood

Theoretical range The classification is achieved with ≥350 g/m² TEKNOSAFE 2407-00 with or without ≤150 g/m² TEKNOSAFE FLAME PROTECT 2408-00.

Colors Base 1 and base 3 (all opaque colours). All shading recipes are developed by Teknos Shade Service.

Tone system Teknocolor

Gloss (60°) Matt

Dilute Water

Storage Optimal storage temperature is +10 °C - +25 °C. Do not get frost.

INSTRUCTIONS FOR USE

Pre-treatment The wood must be free of wood dust and dirt. The moisture content of the wood must not exceed 18%

Application method Airless spraying, Air-assisted airless spraying Applied industrially.

Application

Nozzle Airless flat 0.28 mm (120-150 bar)

Nozzle Air-assisted airless flat 0.28 mm (80-100 bar) (form air 1.0-1.5 bar)

Application conditions

The temperature of the air, surface and paint must be above +10 °C and the relative humidity below 80% during application and drying. The best result is achieved at an air temperature of between +23 °C and +38 °C and a relative humidity of 50-70% and good ventilation.

The product is stirred carefully before use, preferably by mechanical stirring. V

ed cutting surfaces made on the construction site, the specified treatment system must be re-established.

It is recommended that between all treated solid wood and wood-based panels, a protective material of a minimum thickness of 1.5 mm (e.g. polyethylene film) is laid that does not leave marks.

Drying time +23 °C / 50 % RH

- handling dry 2-3 hours

- dry thoroughly Min. 4 hours An increase in the layer thickness and a higher humidity in the room will usually prolong the drying process. If forced drying is used, contact the supplier for guidance.

Cleaning Water.

Safety and preventive measures See safety data sheet.