Colormatic 2K Hi-Speed Clear Coat Matte

This clearcoat is a 2K matt clearcoat with gloss level (at measuring angle 60° according to DIN 67530) matt with 2 sprays: 20 +/- 10 gloss units (depending on substrate and number of sprays). It comes in a handy 200ml spray to avoid residue. 200 ml is enough for approx. 0.3 - 0.4 m².

The substrate can be both solvent and water-based base colours. They can be painted over with ColorMatic 2K hi-speed clearcoat matt after they have dried for 30 minutes (if the surface is dust-free).

Drying time (at 20°C, 50% relative humidity): Dust dry: after approx. 5 minutes
Dry to the touch: after approx. 5 hours. Note that the drying time depends on the ambient temperature, humidity and the thickness of the applied layer.

Mixing A components with hardener:

Remove the protective cap from the bottom of the can and pull the pin completely out using the inserted ring. This will release the blade which will penetrate the wall of the aluminum cartridge.

The cartridge will then rotate 360°, be fully open and release the hardener. Shake the can vigorously to mix the A components with the hardener in the correct, predetermined ratio. Shake the can vigorously for 3 minutes. Carry out spray tests.

Note that it is a 2K spray, so the usage time is 24 hours at room temperature (20° C) after activation.

Use suitable respiratory protection (recommended type A2/P3).